Are you searching solution for – how to clean hydraulic fluid from asphalt pavement or roadways? Untreated asphalt pavement for a long time may worsen the condition and as a result, more costs may require to repair the area.
Asphalt pavement is made by mixing sand, stone aggregates, and asphalt.
This mixer is porous and hence absorbs the hydraulic fluid which may pour accidentally on the pavement or roadway.
In long run, hydraulic fluid or oil spill on the road or pavement may harm in two ways. It leaves a stain that is hard to clean in long run.
Secondly, if you have to mark the area using paint for any reason, hydraulic fluid or oil spill resist capturing the paint.
Four ways you can get rid of hydraulic fluid from asphalt roadway or pavement.
- Use of cat litter to clean hydraulic fluid from asphalt.
- Use of Coca-cola to clean hydraulic fluid from asphalt.
- Use of oven cleaner to clean hydraulic fluid from asphalt
- Use of household stain remover to clean hydraulic fluid from asphalt
Before understanding these cleaning methods, I would like to bring up that it is better to take a precaution to avoid getting stains from oil or hydraulic spill.
I think precaution should be your priority. Use of Sealcoat is that prevention tactic.
Sealcoat acts as a protective coat for asphalt against oxidation, UV rays, and water penetration beside oil stains.
To clear oil stains from asphalt follow one of the following methods which suit you. You may choose any method as per the availability of the required main ingredient to clean hydraulic fluid from asphalt.
Before starting anyone method as per your choice, I would recommend you clean hydraulic fluid or oil as much as possible mechanically by wiping and moping out.
Use of cat litter to clean hydraulic fluid from asphalt.
Step 1: Mop up hydraulic fluid from the asphalt as much as possible.
Step 2: Take cat litter. Crush makes small particles of the same at the extent possible level.
Step 3: Lay over the crushed cat litter on the infested area.
Step 4: Stroke or pat it properly to increase the effectiveness of absorption of hydraulic fluid.
Step 5: Leave cat litter for one night to get the best results.
Step 6: Clean the cat litter in the morning by collecting it after simple sweeping.
Step 7: Now, lastly clean the surface using water. You can hose down the same. If a hose pipe is not available, use a bucket to pour the water.
Step 8: If you found that, some stains are remaining, use detergent soap to clean the same. Clean it using a scrub brush with steep bristles.
Use of Coca-cola to clean hydraulic fluid from asphalt
Step 1: Mop up hydraulic fluid from the asphalt as much as possible.
Step 2: Take Coca-cola cans or bottles available at your disposal. Pour it on the hydraulic oil on asphalt.
Step 3: Keep the same at least for 20-25 minutes. This much time is required to become it inactive. Once you find that cola is flat; you can go to the next step.
Step 4: Again pour a little amount or a can of Coca-cola on the same spot and rub it with a cleaning brush. Mix it well so as could pull out the hydraulic fluid from the asphalt.
Step 5: Rinse the remaining with water using a hose pipe or a bucket and you are done.
Step 6: If you found that, some stains are remaining, use detergent soap to clean the same. You have to clean the same using a scrub brush.
Use of oven cleaner to clean hydraulic fluid from asphalt
Step 1: Mop up hydraulic fluid from the asphalt as much as possible. You can also follow the method mentioned above.
If you do not have cat litter with you, you can use porous clay to absorb hydraulic fluid before applying oven cleaner.
Step 2: Take a good quality oven cleaner and spray it well over the stain. While spaying the oven cleaner you should apply oven cleaner to the extent that the hydraulic fluid stain gets saturated.
Step 3: After oven cleaner application to the saturation level, leave it at least for 30 – 40 minutes. It will allow the oven cleaner to do its job to neutralize hydraulic fluid and will break it down.
Step 4: Now, after 30 – 40 minutes, just rinse the spot with water. You can use a hose pipe to clean the spot easily. I will be recommended to spray water with some force to remove stains effectively.
Use of household stain remover to clean hydraulic fluid from asphalt
Step 1: Mop up hydraulic fluid from the asphalt as much as possible.
Step 2: You can take any household cleaner available in your cabinet. You can try dishwashing liquid, soap, or vinegar. While using vinegar, you should dilute it before use.
Step 3: After applying any of the abovementioned household cleaners, scrub the area with a rigid brush to clean the spot.
Step 4: After scrubbing the stain leave it for 20-30 minutes and allow the cleaner to eat out the hydraulic fluid.
Step 5: Now hose out the satin with water completely.
Step 6: if you found that, still stain is reaming though the intensity of the stain is reduced, repeat the process until you get rid of the hydraulic fluid stain.
If you are not able to get rid of hydraulic fluid after following the four methods described above, stains are sturdy.
To clean such sturdy and hard stains, I will recommend you to take the help of professionals to complete the task.
Precautions to be taken while cleaning Hydraulic Fluid from Asphalt?
- Do not throw oil collected cat litter anywhere as after rain oil may get carried to groundwater along with water flow.
- Keep children and pets away while using oven cleaner.
- Follow safety instructions while performing the cleaning process.
Conclusion:
I am sure that you have defiantly got an answer to your question – How to Clean Hydraulic Fluid from Asphalt? Using 4 methods along with easy steps to follow, you can take care of hydraulic fluid from the asphalt.